Drag H40 : Compact and elegant
To the touch, this new kit proposed by Voopoo is a real softness. Indeed, the zinc alloy and the leather outline of this Drag H40 kit give it a very pleasant grip. Especially since, with dimensions of 104.5 x 27.5 x 26mm, this kit fits everywhere. Transport is simple while ergonomics is perfect. A light kit, small, pleasant but above all powerful.
Deux modes de fonctionnement
Despite its minimal dimensions, this Drag H40 kit offers vapers a range of high-end technical features. For example, the power varies between 5 and 40W. For this style of pod, the 40W in maximum power are very appreciable and allow to enjoy a good voluminous vape.
The Drag H40 offers two modes of operation to enjoy this power. There is the RBA mode that leaves power control to the user. Simply choose the power via the two selection buttons on the front of the kit. There is also the Smart mode. As the name suggests, this mode automatically determines the ideal power according to the equipped resistance.
To operate everything, we find a built-in battery with a wide range of 1500mAh. This autonomy offers a certain freedom to the vaper who does not see itself recharge the device too often. About charging, it is done via a USB Type-C cable (supplied) to plug in below the kit.
To finish with the technical functions, this kit has a small 0.54 inch OLED screen that indicates the battery level, power, mode, resistance value as well as the number of puffs. Finally, just above the screen is the main activation button.
A large cartridge of 5ml
The battery is supplemented by a PnP II cartridge. This cartridge, which clip and unclip in one movement with its magnetic connection, is a capacity of 5ml. A capacity high enough to, once again, facilitate the life of the vaper that will not fill the cartridge too often. However, when the filling time rings, simply unclip the cartridge and remove the tab on the side to access the filling hole.
This new cartridge is compatible with a large number of PnP resistors. These resistances are known for their longevity and their rendering of flavors. In the purchase kit of the Drag H40, two resistors are included, it is a PnP-TW30 of 0.3ohm and a PnP-VM3 of 0.45 ohm (pre-installed).
In short, this Drag H40 kit produced by Voopoo is a kit for apprentice vapers since it is very easy to use. However, as an extra e-cig, this Drag H40 will also be perfect. It should appeal to all lovers of big vape thanks to its power and resistance. Finally, aesthetically, this kit is a real success as pleasant to look at as to hold in hand.
1 x Drag Battery H40
1 x Pnp II 5ml cartridge
1 x Pnp-VM3 (pre-installed)
1 x PnP-TW30
1 x USB-C cable
1 x PnP Board
1 x User manual