RPM 85 - Smoktech

Un design compact et coloré 

For this new range of pods, Smok has chosen to make compact pods that fit perfectly in the hand. Indeed, with dimensions of 128.5 x 36 x 29mm, the RMP85 kit is equipped with the IML (In Mould Labeling) technique highlighting the know-how of the brand. As for the weight, the RMP85 weighs only 162.5g. Light and compact, this kit will follow the vapoteur in all circumstances. 

Un kit endurant 

More and more pods tend towards a great autonomy for a rather consequent power, the RPM85 does not depart from this rule. Indeed, it is equipped with an integrated battery of 3000mAh. This is enough to last a whole day even at its maximum capacity, that is to say, at 85W of power. Of course, it is possible to vary the power which, at least, starts at 5W. 

To monitor the correct operation of the kit, the power used or the remaining autonomy, the RPM85 has a 0.96 inch color TFT screen. A nice screen placed on the front panel just between the main activation button and the selection buttons "+" "-". 

To finish with the composition of the front of this kit, just below the screen and buttons, we find the USB Type-C port to perform the charging. This one is in fast charging with the cable provided in the purchase kit. 

Un système d'airflow rotatif et une cartouche bien pensée

The pod RPM85 is complemented by the cartridge RPM3 with a capacity of 6ml. It is therefore a tank large enough to enjoy the flavors of e-liquid without having to reload too often. For the reloading, it is done from the top after shifting the top cap. The RPM3 cartridge is clipped and unclipped without difficulty thanks to its magnetic connection with the pod. Finally, for the replacement of the resistance, there is a latch, with a child safety, which allows to empty the cartridge from the bottom of the latter. 

Speaking of resistance, the cartridge is compatible with the RPM3 resistors from Smok. The cartridge is sold with a resistance 0.15 ohm and a resistance 0.23ohm. We are therefore facing a kit specialized in a DL draw, thick and air. 

To allow this dense steam, the kit has a rotating ring to change the airflow. So just turn the ring located on the top of the box to more or less let the air through. 

Note that the RPM85 kit is also compatible with all RPM2 resistors, but for this, you need an RPM2 cartridge (sold separately). 

Contents 

1 x Box RPM85

1 x RPM3 cartridge

1 x RPM3 resistor 0.15Ω

1 x RPM3 0.23Ω resistor

1 x USB Type-C cable

1 x User Manual