Cartouche Pod PAL II 3ml - Artery
Cartouche Pod PAL II 3ml - Artery

By buying this product you can collect up to 3 points. Your cart will total 3 points that can be converted into a voucher of €0.30.

Cartouche Pod PAL II 3ml - Artery
Cartouche Pod PAL II 3ml - Artery
Cartouche Pod PAL II 3ml - Artery
Cartouche Pod PAL II 3ml - Artery Cartouche Pod PAL II 3ml - Artery

Cartouche Pod PAL II 3ml - Artery

3ml PAL II Pod Cartridge - Artery

The replacement cartridge for the Artery PAL 2 Kit can contain 3ml of e-liquid and is designed to work with the two types of PAL 2 resistors also marketed by Artery: Regular 1.2ohm resistors and Mesh 0.6ohm resistors. Thanks to this cartridge, you will be able to switch between MTL and DL vapour, adjust your airflow thanks to the ring located under the cartridge, and never run out of e-liquid! Depending on the resistance you choose to use, you can choose an e-liquid compound on a basis between 50/50 PG/VG and 30/70 PG/VG.

Product description

Warning, no resistance is provided with this cartridge. It is also only compatible with the PAL 2 kit marketed by Artery, so make sure your hardware is compatible before any purchase.


Artery’s PAL 2 cartridges can only be used with the same brand PAL 2 kit.

This reusable cartridge is identical to the one provided in the PAL 2 kit. It can hold 3ml of e-liquid and will allow you to adjust your airflow thanks to a ring located below. It also includes a proprietary drip-tip adapted to the shape of your lips for better ergonomics, and above all, it is equipped with a lateral filling system that will allow you to refuel e-liquid without having to declip it from your pod: ultra practical!

For the e-liquid refill, you will just have to place your PAL 2 kit flat and remove the silicone cover directly accessible. Once your liquid has been poured through the filling hole, you will need to replace the cover correctly for an effective seal.

The PAL 2 cartridge must be combined with a PAL 2 resistor in order to operate. You will be able to buy separately PAL 2 Mesh 0.6ohm or Regular 1.2ohm resistors for your cartridge, these are not provided with the replacement cartridge.

To proceed with the insertion of the resistance, it will be necessary to take it out of the PAL 2 kit while making sure to press on the drip-tip while pushing it towards you in order to be able to declip the cartridge, as indicated on it by the inscription «Push» decorated with an arrow down. Then, you can gently pull the cartridge out of the pod, still holding it by the drip-tip, then proceed to the installation of your resistance.

You can use an e-liquid between 50/50 and 30/70 PG/VG with a 1.2ohm resistance and an e-liquid at 30/70 PG/VG with your 0.6ohm resistance to get the best out of it.

The PAL 2 cartridge is sold individually.

Indirect or direct 3 ml Résistances PAL 2 - Artery

Technical sheet

Modes de Vape Indirect or direct
Capacity 3 ml
Résistances Résistances PAL 2 - Artery